Planet WGSW-28040 - Show Ip Dhcp Snooping Option

Command Guide of WGSW-28040
111
Command:
ip dhcp snooping option remote-id STRING
no ip dhcp snooping option remote-id
Parameter:
STRING
Remote-id string, 1 to 63 ASCII characters, no spaces.
Default:
Default remote-id is the switch MAC address in byte order
Mode:
Global Configuration
Usage Guide:
Use the ip dhcp snooping option remote-id command to set user-defined remote-id string.
Remote-id is an global and unique string. Use the no form of this command to default setting.
Example:
The example shows how to set a user-defined remote-id string on switch. You can verify settings by the following
show ip dhcp snooping option remote-id
switch(config)# ip dhcp snooping option remote-id test_remote
switch(config)# do show ip dhcp snooping option remote-id
Remote ID: test_remote
4.6.14 show ip dhcp snooping option
Command:
show ip dhcp snooping option remote-id
Mode:
Global Configuration
Usage Guide:
Use the show ip dhcp snooping option remote-id command to show remote-id string.
Example:
The example shows how to show remote-id string