Planet WGSW-28040 - Qos Map

Command Guide of WGSW-28040
259
CoS-DSCP:
Trust DSCP for IP packets and assign queue according to dscp-queue map. Trust CoS for non-IP packets and assign
queue according to cos-queue map.
Example:
This example shows how to change qos basic mode trust types.
Switch(config)# qos trust cos
Switch(config)# qos trust cos-dscp
Switch(config)# qos trust dscp
Switch(config)# qos trust precedence
This example shows how to check current qos trust type.
Switch# show qos
QoS Mode: basic
Basic trust: cos
4.21.3 qos map
Command:
qos map (cos-queue | dscp-queue | precedence-queue) SEQUENCE to <1-8>
qos map (queue-cos | queue-precedence) SEQUENCE to <0-7>
qos map queue-dscp SEQUENCE to <0-63>
Parameter:
cos-queue
Configure or show CoS to queue map
dscp-queue
Configure or show DSCP to queue map
precedence-queue
Configure or show IP Precedence to queue map.
queue-cos
Configure or show queue to CoS map
queue-dscp
Configure or show queue to DSCP map
queue-precedence
Configure or show queue to IP Precedence map
SEQUENCE
Specify the cos, dscp, precedence or queue with one or multiple values.
<1-8>
Specify th queue id