Command Guide of WGSW-28040
175
4.13.2 lldp tx-interval
Command:
lldp tx-interval <5-32768>
Parameter:
Specify the LLDP PDU TX interval in unit of second.
Default:
lldp tx-interval 30
Mode:
Global Configuration
Usage Guide:
This command globally configures the LLDP TX interval. It should be noticed that both “lldp tx-interval” and “lldp
tx-delay” affects the LLDP PDU TX time. The larger value of the two configuration decides the TX interval. The
configuration could be shown by “show lldp” command.
Example:
This example sets LLDP TX interval to 10 seconds.
Switch(config)# lldp tx-interval 10
Switch# show lldp
State: Disabled
Timer: 10 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
LLDP packet handling: Flooding
4.13.3 lldp reinit-delay
Command:
lldp reinit-delay <1-10>
Parameter:
To Next Page
Loading...
