Planet WGSW-28040 - Show Management-Vlan; Protocol-Vlan Group

Command Guide of WGSW-28040
341
Mode:
Global Configuration
Usage Guide:
(1) Set <1-4094> as management VLAN id; suggest to create the VLAN and make the port to be member of it firstly.
(2) When use no command, restore management vlan to be default VLAN.
(3) If want to see management vlan created ,use “show management-vlan”
Example:
The following example specifies that management vlan 2 is created
Switch(config)# management-vlan vlan 2
4.29.17 show management-vlan
Command:
show management-vlan
Parameter:
login
Add/Edit login authentication list
enable
Add/Edit enable authentication list
default
Edit default authentication list
Mode:
Global Configuration
Usage Guide:
Display information about management vlan
Example:
The following example specifies that show management vlan
Switch(config)# show management-vlan
4.29.18 protocol-vlan group
Command: