Planet WGSW-28040 Command Guide

Command Guide of WGSW-28040
66
4.4 Administration
4.4.1 enable
Command:
enable [<1-15>]
disable [<1-14>]
Parameter:
<1-15>
Specify privileged level to enable
<1-14>
Specify privileged level to enable
Default:
Default privilege level is 15 if no privilege level is specified on enable command.
Default privilege level is 1 if no privilege level is specified on disable command.
Mode:
User EXEC
Usage Guide:
In User EXEC mode, user only allows to do a few actions. Most of commands are only available in privileged EXEC
mode. Use “enable” command to enter the privileged mode to do more actions on switch.
In privileged EXEC mode, use “exit” command is able to go back to user EXEC mode with original user privilege level.
If you need to go back to user EXEC mode with different privilege level, use “disable” command to specify the
privilege level you need.
In privileged EXEC mode, the prompt will show “Switch#”
Example:
This example shows how to enter privileged EXEC mode and show current privilege level.
Switch> enable
Switch# show privilege
Current CLI Username:
Current CLI Privilege: 15
This example show how to enter user EXEC mode with privilege 3.

Planet WGSW-28040 Specifications

General

Brand	Planet
Model	WGSW-28040
Category	Switch
Language	English