Planet WGSW-28040 - Multicast

Command Guide of WGSW-28040
122
TCP Fragment (Offset = 1) | enabled
4.7.2 port dos
Command:
dos
no dos
Default:
Default value is disable
Mode:
Interface Configuration
Usage Guide:
Use “dos” command to enable dos configuration on selected ports. Use “no dos” to diable on selected ports.
Example:
This example shows how to show current dos state on interface gi1
Switch# show dos interfaces gi1
Port | DoS Protection | Gratuitous-ARP
----------+----------------+----------------
gi1 | enabled | disabled
4.7.3 ip gratuitous-arps
Command:
ip gratuitous-arps
no ip gratuitous-arps
Default:
Default value is disable
Mode: