Planet WGSW-28040 - Eee

Command Guide of WGSW-28040
253
This example shows how to show current protected port state.
Switch# show interfaces gi1-2 protected
Port | Protected State
-------+-----------------
gi1 |enabled
gi2 |enabled
4.20.8 eee
Command:
eee
no eee
Default:
Default eee state is disabled.
Mode:
Interface Configuration
Usage Guide:
Use “eee” command to make port to enable the energy efficient Ethernet feature and use “no eee” command to
disable it.
The only way to show this configuration is using “show running-config” command.
Example:
This example shows how to configure port gi1 to be protected port.
Switch(config)# interface gi1
Switch(config-if)# eee
This example shows how to show current jumbo-frmae size
Switch# show running-config interface gi1
interface gi1
eee