Planet WGSW-28040 - Show Storm-Control

Command Guide of WGSW-28040
299
Switch# show storm-control interfaces gi1
Port | State | Broadcast | Unkown-Multicast | Unknown-Unicast | Action
| | pps | pps | pps |
---------+-------+------------+--------------------+-----------------|-----------
gi1 disable Off( 10000) Off( 10000) Off( 10000) Shutdown
4.25.5 show storm-control
Command:
show storm-control
show storm-control interface IF_PORTS
Parameter:
IF_PORTS
Specify port to show.
Mode:
Privileged EXEC
Usage Guide:
Use “show storm-control” command to show all storm control related configurations including global configuration
and per port configurations.
Use “show storm-control interface” command to show selected port storm control configurations.
Example:
This example shows how to show storm control global configuration.
Switch# show storm-control
Storm control preamble and IFG: Excluded
Storm control unit: pps
..........................................
This example shows how to show current storm control configuration on interface gi1
Switch# show storm-control interfaces gi1
Port | State | Broadcast | Unkown-Multicast | Unknown-Unicast | Action
| | pps | pps | pps |