Planet WGSW-28040 - Spanning-Tree Link-Type; Spanning-Tree Mst Configuration

Command Guide of WGSW-28040
312
Switch# configure
Switch(config)# interface gi1
Switch(config-if)# spanning-tree bpdu-guard
4.26.16 spanning-tree link-type
Command:
spanning-tree link-type ( point-to-point | shared )
no spanning-tree link-type
Parameter:
( point-to-point |
shared )
Specify the STP port link-type to Point-to-Point or Shared medium.
Mode:
Port Configuration
Usage Guide:
This command per port configures the STP port link-type. The configuration could be shown by “show spanning-tree
interface” command.
Example:
This example sets port gi1 STP port link-type to be Shared.
Switch# configure
Switch(config)# interface gi1
Switch(config-if)# spanning-tree link-type shared
4.26.17 spanning-tree mst configuration
Command:
spanning-tree mst configuration