Command Guide of WGSW-28040
296
storm-control ifg (include | exclude)
Parameter:
Include preamble & IFG (20 bytes) when count ingress storm control rate.
Exclude preamble & IFG (20 bytes) when count ingress storm control rate
Default:
Default storm control inter frame gap is excluded.
Mode:
Global Configuration
Usage Guide:
Storm control mechanism will try to calculate ingress packets is exceed configured rate or not and do corresponding
action. This command allows you to decide to include/exclude the preamble and inter frame gap into the calculating
or not.
Example:
This example shows how to configure storm control rate unit as pps.
Switch(config)# storm-control ifg include
This example shows how to show storm control global configuration.
Switch# show storm-control
Storm control preamble and IFG: Included
Storm control unit: pps
..........................................
4.25.3 storm-control
Command:
storm-control
no storm-control
storm-control (broadcast | unknown-unicast | unknown-multicast)
To Next Page
Loading...
