Planet WGSW-28040 - Lldp Med Network-Policy

Command Guide of WGSW-28040
187
4.13.14 lldp med network-policy
Command:
lldp med network-policy <1-32> app
(voice|voice-signaling|guest-voice|guest-voice-signaling|softphone-voice|
video-conferencing|streaming-video|video-signaling) vlan <1-4094> vlan-type
(tag|untag) priority <0-7> dscp <0-63>
no lldp med network-policy <1-32>
Parameter:
<1-32>
Specify the network policy index
(voice|voice-signali
ng|guest-voice|gue
st-voice-signaling|s
oftphone-voice|
video-conferencing
|streaming-video|vi
deo-signaling)
Specify the network policy application type.
<1-4094>
Specify the VLAN ID
(tag|untag)
Specify the VLAN tag status
<0-7>
Specify the L2 priority
<0-63>
Specify the DSCP value
Mode:
Global Configuration
Usage Guide:
The commands globally configures the LLDP MED network policy table. The “lldp med network-policy” command
created a network policy entry that can be bind to ports. If LLDP MED network policy voice auto mode is enabled,
“voice” type network policy can not be created since it is in auto mode. The “no lldp med network-policy” command
clear the network policy entry of the specified index. A network policy can be cleared only when it is not bind to any
port. The network policy table configuration could be shown by “show lldp med” command.
Example:
This example create 2 network policies.
Switch(config)# aaa authentication login test1 tacacs+ radius local
Switch(config)# lldp med network-policy 1 app voice-signaling vlan 2 vlan-type tag