Planet WGSW-28040 - Page 146

Command Guide of WGSW-28040
146
variable <1-7>
Default:
no ip igmp snooping vlan 1-4094 last-member-query-count
no ip igmp snooping vlan 1-4094 last-member-query-interval
ip igmp snooping vlan 1-4094 router learn pim-dvmrp
no ip igmp snooping vlan 1-4094 fastleave
no ip igmp snooping vlan 1-4094 query-interval
no ip igmp snooping vlan 1-4094 response-time
no ip igmp snooping vlan 1-4094 robustness-variable
Mode:
Global Configuration
Usage Guide:
‘no ip igmp snooping vlan 1 (last-member-query-count | last-member-query-interval | query-interval | response-time |
robustness-variable)’ will set the vlan parameters to default.
The cli setting will change the ip igmp vlan parameters admin settings.
The configure can use show ip igmp snooping vlan 1.
Example:
The following example specifies that set ip igmp snooping vlan parameters test.
Switch(config)# ip igmp snooping vlan 1 fastleave
Switch(config)# ip igmp snooping vlan 1 last-member-query-count 5
Switch(config)# ip igmp snooping vlan 1 last-member-query-interval 3
Switch(config)# ip igmp snooping vlan 1 query-interval 100
Switch(config)# ip igmp snooping vlan 1 response-time 12
Switch(config)# ip igmp snooping vlan 1 robustness-variable 4
Switch# show ip igmp snooping vlan 1
IGMP Snooping is globaly enabled
IGMP Snooping VLAN 1 admin : enabled
IGMP Snooping operation mode : enabled
IGMP Snooping robustness: admin 4 oper 2
IGMP Snooping query interval: admin 100 sec oper 125 sec
IGMP Snooping query max response : admin 12 sec oper 10 sec
IGMP Snooping last member query counter: admin 5 oper 2
IGMP Snooping last member query interval: admin 3 sec oper 1 sec
IGMP Snooping last immediate leave: enabled
IGMP Snooping automatic learning of multicast router ports: enabled