Planet WGSW-28040 - Page 193

Command Guide of WGSW-28040
193
show lldp local-device
show lldp interfaces IF_NMLPORTS local-device
Parameter:
IF_NMLPORTS
Specify the ports to display information
Mode:
Privileged Configuration
Global Configuration
Usage Guide:
The commands show the local configuration of LLDP PDU. By the commands, a user can view the contents of LLDP/
LLDP-MED TLVs that would be attached in LLDP PDU.
Example:
This example displays the local device information.
Switch(config)# show lldp local-device
LLDP Local Device Information:
Chassis Type : Mac Address
Chassis ID : 00:12:12:12:12:12
System Name : Switch
System Description :
System Capabilities Support : Bridge
System Capabilities Enable : Bridge
Management Address : 192.168.1.254(IPv4)
Switch(config)# show lldp interfaces gi1 local-device
Device ID: 00:12:12:12:12:12
Port ID: gi1
System Name: Switch
Capabilities: Bridge
System description:
Port description:
Management address: 192.168.1.254
Time To Live: 120
802.3 MAC/PHY Configur/Status
Auto-negotiation support: Supported
Auto-negotiation status: Enabled
Auto-negotiation Advertised Capabilities: 10BASE-T half duplex, 10BASE-T full duplex,