Planet WGSW-28040 - Page 217

Command Guide of WGSW-28040
217
Command:
show mirror [session <1-4>]
Parameter:
<1-4>
Specify the mirror session to display
Mode:
Privileged EXEC
Usage Guide:
Use the show mirror command in EXEC mode to display mirror session configuration
Example:
This example shows how to display mirror session configuration
Switch(config)# show mirror
Session 1 Configuration
Source RX Port : gi2-5
Source TX Port : gi2-5
Destination port : gi1
Ingress State: disabled
Session 2 Configuration
Mirrored source : Not Config
Destination port : Not Config
Session 3 Configuration
Mirrored source : Not Config
Destination port : Not Config
Session 4 Configuration
Mirrored source : Not Config
Destination port : Not Config