Command Guide of WGSW-28040
245
Parameter:
Specify the auto recovery interval with unit second.
Default:
Default auto recovery interval is 300 second.
Mode:
Global Configuration
Usage Guide:
Port will be disabled by some invalid actions detected by protocols. Auto recovery mechanism will enable these error
disabled port after a while. This command configures how long the port will be enabled after error disabled.
Example:
This example shows how to configure the auto recovery interval to 600 seconds.
Switch(config)# errdisable recovery interval 600
This example shows how to show current auto recovery interval
Switch# show errdisable recovery
ErrDisable Reason | Timer Status
--------------------------+---------------
bpduguard | enabled
udld | disabled
selfloop | disabled
broadcast-flood | enabled
unknown-multicast-flood | disabled
unicast-flood | disabled
acl | disabled
psecure-violation | disabled
dhcp-rate-limit | disabled
arp-inspection | disabled
Timer Interval : 600 seconds
Interfaces that will be enabled at the next timeout:
Port | Error Disable Reason | Time Left
-----+----------------------------+------------
To Next Page
Loading...
