Planet WGSW-28040 - Page 269

Command Guide of WGSW-28040
269
IF_PORTS
Select port to show qos configurations.
Mode:
Privileged EXEC
Usage Guide:
Use “show qos interfaces” command to show port default cos ,remarking state and remarking type state
informations.
Example:
This example shows how to show qos configurations on interface gi1.
Switch# show qos interface GigabitEthernet 1
Port | CoS | Trust State | Remark Cos | Remark DSCP | Remark IP Prec
--------+-------+---------------+------------+-------------+----------------
gi1 | 7 | enabled | disabled | disabled | disabled |