Command Guide of WGSW-28040
29
Mode:
Global Configuration
Usage Guide:
Use the dot1x guest-vlan command to globally enable guest VLAN function. Use the no form of this command to
disable guest VLAN function.
For a port to become a member of guest VLAN after authentication fail, you should also enable guest VLAN on that
port.
Example:
The example shows how to configure VLAN 2 as guest VLAN and enable guest VLAN on port 1.
switch(config)# dot1x guest-vlan 2
switch(config)# interface gi1
switch(config-if)# dot1x auto
switch(config-if)# dot1x guest-vlan
switch(config-if)# exit
switch(config)# show dot1x guest-vlan
Guest VLAN ID: 2
Port | Guest VLAN | In Guest VLAN
-------+------------+---------------
gi1 | Enabled | No
gi2 | Disabled | ---
gi3 | Disabled | ---
gi4 | Disabled | ---
gi5 | Disabled | ---
gi6 | Disabled | ---
gi7 | Disabled | ---
gi8 | Disabled | ---
gi9 | Disabled | ---
gi10 | Disabled | ---
gi11 | Disabled | ---
gi12 | Disabled | ---
gi13 | Disabled | ---
gi14 | Disabled | ---
gi15 | Disabled | ---
gi16 | Disabled | ---
gi17 | Disabled | ---
gi18 | Disabled | ---
To Next Page
Loading...
