Planet WGSW-28040 - Page 55

Command Guide of WGSW-28040
55
[sequence <1-2147483647>] permit icmp (A.B.C.D/A.B.C.D|any) (A.B.C.D/A.B.C.D|any)
(<0-255>|echo-reply|destination-unreachable|source-quench|echo-request|
router-advertisement|router-solicitation|time-exceeded|timestamp| timestamp-reply|traceroute|any)
(<0-255>|any) [(dscp|precedence) VALUE]
[sequence <1-2147483647>] permit tcp (A.B.C.D/A.B.C.D|any) (<0-65535>|echo|
discard|daytime|ftp-data|ftp|telnet|smtp|time|hostname|whois|tacacs-ds|domain|www|
pop2|pop3|syslog|talk|klogin|kshell|sunrpc|drip|PORT_RANGE|any) (A.B.C.D/A.B.C.D|any)
(<0-65535>|echo|discard|daytime|ftp-data|ftp|telnet|smtp|time|hostname|whois|
tacacs-ds|domain|www|pop2|pop3|syslog|talk|klogin|kshell|sunrpc|drip|PORT_RANGE|any)
match-all TCP_FLAG] [(dscp|precedence) VALUE]
[sequence <1-2147483647>] permit udp (A.B.C.D/A.B.C.D|any)
(<0-65535>|echo|discard|time|nameserver|tacacs-ds|domain|bootps|bootpc|tftp|sunrpc|ntp|netbios-n
s|snmp| snmptrap|who|syslog|talk|rip|PORT_RANGE|any) (A.B.C.D/A.B.C.D|any)
(<0-65535>|echo|discard|time|nameserver|tacacs-ds|domain|bootps|bootpc|tftp|sunrpc|ntp|netbios-n
s| snmp|snmptrap|who|syslog|PORT_RANGE|any)[(dscp|precedence) VALUE]
no sequence <1-2147483647>
Parameter:
<1-2147483647>
(Optional) Specify sequence index of ACE, the sequence index represent the priority of
an ACE in ACL.
(A.B.C.D/A.B.C.D|a
ny)
Specify the source IPv4 address and mask of packet or any IPv4 address.
(A.B.C.D/A.B.C.D|a
ny)
Specify the destination IPv4 address and mask of packet or any IPv4 address.
[dscp VALUE]
(Optional) Specify the DSCP of packet.
[precedence
VLAUE]
(Optional) Specify the IP precedence of packet.
icmp-type
Specify ICMP message type for filtering ICMP packet. Enter a type name of list or a
number of ICMP message type.
icmp-code
Specify ICMP message code for filtering ICMP packet.
igmp-type
Specify IGMP type for filtering IGMP packet. Enter a type name of list or a number of
IGMP type.
l4-source-port
Specify TCP/UDP source port of for filtering TCP/UDP packet. Enter a port name of list
or a number of TCP/UDP port.
l4-destination-port
Specify TCP/UDP destination port of for filtering TCP/UDP packet. Enter a port name of
list or a number of TCP/UDP port.