Planet WGSW-28040 Command Guide

Command Guide of WGSW-28040
86
Parameter:
<0-120>
Specify password fail retry number. 0 means no limit.
Default:
Default password fail retry number is 3.
Mode:
line Configuration
Usage Guide:
Use “password-thresh” command to specify the password fail retry number for CLI running on console, telnet or ssh
service. When user input password to login and authenticate failed, the fail retry number will increase one. After fail
retry number exceed configured one, the CLI will block login for the period of silent time which configured by the
command “silent-time”.
Example:
This example shows how to change console fail retry number to 4, telnet fail retry number to 5 and ssh fail retry
number to 6.
Switch(config)# line console
Switch(config-line)# password-thresh 4
Switch(config-line)# exit
Switch(config)# line telnet
Switch(config-line)# password-thresh 5
Switch(config-line)# exit
Switch(config)# line ssh
Switch(config-line)# password-thresh 6
Switch(config-line)# exit
This example shows how show line information.
Switch# show line
Console ==============================
Session Timeout : 10 (minutes)
History Count : 128
Password Retry : 4
Silent Time : 0 (seconds)
Telnet ===============================
Telnet Server : disabled
Session Timeout : 10 (minutes)
History Count : 128

Planet WGSW-28040 Specifications

General

Brand	Planet
Model	WGSW-28040
Category	Switch
Language	English