Booklet Finisher SR3000 (B793)
D086/D087 2-72 SM
6. Attach the rear joint bracket [F] (
x 2, M4 x 14).
7. Attach the front joint bracket [G] and the holder bracket [H] (
x 2; M4 x 14).
The holder bracket [H] must be placed outside the front joint bracket [G]. The
holder bracket is provided with the bridge unit (D386).
8. Pull the lock lever [I] (Long knob screw x 1).
9. Slowly push the finisher to the left side of the machine, keeping its front door open until
the brackets [J] [K] go into their slots.
10. Push the lock lever [I], and then secure it (Long knob screw x 1).
11. Close the front door of the finisher.
12. Connect the finisher connector [L] to the machine.
To Next Page
Loading...
