Bit Switches
D393 76 SM
System Switch 12 [SP No. 1-101-019]
No FUNCTION COMMENTS
0-7
TTI printing position in the
main scan direction
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for
the TTI from the left edge of the paper. If the TTI is
moved too far to the right, it may overwrite the file
number which is on the top right of the page. On
an A4 page, if the TTI is moved over by more than
50 mm, it may overwrite the page number.
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 [SP No. 1-101-022]
No FUNCTION COMMENTS
0
Not used
Do not change the settings.
1
Going into the Energy Saver
mode automatically
0: Enabled
1: Disabled
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode.
2-3
Not used
Do not change these settings.
4-5
Interval for preventing the
machine from entering Energy
Saver mode if there is a
pending transmission file.
Bit 5: 0, Bit 4: 0
1 min
Bit 5: 0, Bit 4: 1
If there is a file waiting for transmission, the
machine does not go to Energy Saver mode
during the selected period.
After transmitting the file, if there is no file waiting
for transmission, the machine goes to the Energy
Saver mode.
To Next Page
Loading...
