Bit Switches
SM 73 D545
Fax option
Type C5501
D545
6
Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
This switch becomes effective only when
system switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications with
errors.
NOTE: The memory size is limited. Use this bit
switch only when some log reports are
necessary.
7
Priority given to various types of
remote terminal ID when
printing reports
0: RTI > CSI > Dial label > Tel.
number
1: Dial label > Tel. number > RTI
> CSI
This bit determines which set of priorities the
machine uses when listing remote terminal
names on reports.
Dial Label: The name stored, by the user, for
the Quick/Speed Dial number.
System Switch 0A (SP No. 1-101-011)
No Function Comments
0
Automatic port selection
0: Disabled, 1: Enabled
When "1" is selected, a suitable port is
automatically selected if the selected port is not
used.
NOTE: This bit is useful if all communication
lines at a customer site are not same quality.
1-2 Not used Do not change these settings.
3
Continuous polling reception
0: Disabled 1: Enabled
This feature allows a series of stations to be
polled in a continuous cycle. This will continue
until the polling reception file is erased.
The dialing interval is the same as memory
transmission.
4
Dialing on the ten-key pad when
the external telephone is
off-hook
0: Disabled 1: Enabled
0: Prevents dialing from the ten-key pad while
the external telephone is off-hook. Use this
setting when the external telephone is not by
the machine, or if a wireless telephone is
To Next Page
Loading...
