Bit Switches
D545 72 SM
System Switch 09 (SP No. 1-101-010)
No Function Comments
0
Addition of image data from
confidential transmissions on
the transmission result report
0: Disabled 1: Enabled
If this feature is enabled, the top half of the first
page of confidential messages will be printed
on transmission result reports.
1
Print timing of communication
reports on the Journal when no
image data was exchanged.
0: After DCS/NSS
communication (default),
1: After polling
0: Journal is printed only when image data is
sent.
1: Journal is printed when any data is sent.
2
Automatic error report printout
0: Disabled 1: Enabled
0: Error reports will not be printed.
1: Error reports will be printed automatically
after failed communications.
3
Printing of the error code on the
error report
0: No 1: Yes
1: Error codes are printed on the error reports.
This can be used for detecting an error which
rarely occurs.
4 Not used Do not change this setting.
5
Power failure report
0: Disabled
1: Enabled (default)
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when
the power was turned off last.
NOTE: If "0" is selected, no reports are printed
and no one may recognize that fax data is gone
due to a power failure.
To Next Page
Loading...
