Rohde & Schwarz MXO 4 Series - Common Trigger Settings

TriggerMXO 4 Series
142User Manual 1335.5337.02 ─ 07
7.2 Common trigger settings
Access: "Menu" > "Trigger" > "Setup" tab
The common trigger settings are the trigger source and the trigger type, including the
trigger level. To set the trigger level automatically, use "Find level".
These common settings are set once for a single event and are specific for each condi-
tion in a trigger sequence.
Depending on the trigger type, additional settings are available. They are explained in
the trigger-type specific sections.
Trigger on....................................................................................................................142
Source.........................................................................................................................142
Type............................................................................................................................ 143
Level............................................................................................................................143
Find level.....................................................................................................................144
Trigger on
Selects, if you want to trigger on a single event, or on a series of events.
Remote command:
TRIGger:MEVents:MODE on page 540
Source
Selects the source of the trigger signal for the selected trigger event. The trigger
source works even if it is not displayed in a diagram.
Available sources depend on the trigger sequence setting. If you trigger on a single
event, all inputs can be used as trigger source. If you trigger on a sequence, only ana-
log channels can be set as trigger source.
The trigger source can be:
●
Channel <n>: an analog input channel
●
Extern: external analog signal connected to the external trigger input. For the exter-
nal trigger source, the analog edge trigger is available.
Common trigger settings