Rohde & Schwarz MXO 4 Series - Spectrum Gate

Remote control commandsMXO 4 Series
653User Manual 1335.5337.02 ─ 07
Parameters:
<Enable> ON | OFF
Usage: Asynchronous command
Manual operation: See "Traces" on page 249
CALCulate:SPECtrum<sp>:WAVeform:MINimum:ENABle <Enable>
Enables the minimum trace.
Suffix:
<sp>
.
1
Parameters:
<Enable> ON | OFF
Usage: Asynchronous command
Manual operation: See "Traces" on page 249
CALCulate:SPECtrum<sp>:WAVeform:NORMal[:ENABle] <Enable>
Enables the normal spectrum trace.
Suffix:
<sp>
.
1
Parameters:
<Enable> ON | OFF
Usage: Asynchronous command
Manual operation: See "Traces" on page 249
17.14.2 Spectrum gate
CALCulate:SPECtrum<sp>:GATE:POSition...................................................................... 653
CALCulate:SPECtrum<sp>:GATE:STARt..........................................................................654
CALCulate:SPECtrum<sp>:GATE:STOP.......................................................................... 654
CALCulate:SPECtrum<sp>:GATE:WIDTh.........................................................................654
CALCulate:SPECtrum<sp>:GATE:POSition <Center>
Sets the position of the displayed frequency range.
Suffix:
<sp>
.
1
Parameters:
<Center> Range: -1E+26 to 1E+26
Increment: 0.01
*RST: 0
Default unit: HZ
Spectrum analysis