Rohde & Schwarz MXO 4 Series - Channel Filter

TriggerMXO 4 Series
173User Manual 1335.5337.02 ─ 07
Remote command:
TRIGger:NOISe<m>:PERDivision on page 569
TRIGger:NOISe<m>:RELative on page 570
7.7 Channel filter
Access: "Menu">"Trigger" > "Channel filter"
Trigger filter mode
Selects the filter mode for the trigger channel.
"Off"
The trigger signal is not filtered.
"LF reject"
Frequencies lower than the "LF reject BW" are rejected, higher fre-
quencies pass the filter.
"RF reject"
Frequencies higher than the "RF reject BW" are rejected, lower fre-
quencies pass the filter.
Remote command:
TRIGger:FILTermode on page 570
LF reject BW
Sets the limit frequency limit for the highpass filter of the trigger signal. Frequencies
lower than this value are rejected, higher frequencies pass the filter.
Remote command:
TRIGger:LFReject on page 571
RF reject BW
Sets the limit frequency limit for the lowpass filter of the trigger signal. Frequencies
higher than this value are rejected, lower frequencies pass the filter.
Remote command:
TRIGger:RFReject on page 571
Channel filter