Protocol analysisMXO 4 Series
338User Manual 1335.5337.02 ─ 07
You can trigger on:
●
Start or stop condition
●
Repeated start condition
●
Transfer direction (read or write)
●
Bytes with missing acknowledge bit
●
Specific data pattern in the message
13.3.2 I²C configuration
13.3.2.1 I²C configuration settings
Access: [Apps] key > "Protocol" tab > "I2C" > "Setup".
Make sure that the tab of the correct serial bus is selected.
Protocol type
Displays the protocol type to be decoded.
Remote command:
SBUS<sb>:TYPE on page 704
State
Enables the decoding of the selected bus. The signal icon of the bus appears on the
signal bar.
I²C (option R&S
MXO4-K510)
To Next Page
Loading...
