Rohde & Schwarz MXO 4 Series - Digital Voltmeter

Remote control commandsMXO 4 Series
700User Manual 1335.5337.02 ─ 07
Example:
POW:QUAL:POW:DATA?
Type,Source,Current,Max,Min,Mean,RMS,Std Dev,Event Count,Wave Count
Period,Voltage,nan s,3.40282e+38 s,-3.40282e+38 s,nan s,nan s,nan,0,0
RMS,Voltage,nan V,3.40282e+38 V,-3.40282e+38 V,nan V,nan V,nan,0,0
Chrest Factor,Voltage,nan,3.40282e+38,-3.40282e+38,nan,nan,nan,0,0
Max,Voltage,nan V,3.40282e+38 V,-3.40282e+38 V,nan V,nan V,nan,0,0
RMS,Current,nan A,3.40282e+38 A,-3.40282e+38 A,nan A,nan A,nan,0,0
Chrest Factor,Current,nan,3.40282e+38,-3.40282e+38,nan,nan,nan,0,0
Max,Current,nan A,3.40282e+38 A,-3.40282e+38 A,nan A,nan A,nan,0,0
Usage:
Query only
Asynchronous command
17.15.3 Digital voltmeter
This chapter describes the commands for setting up and querying the results of the
digital voltmeter.
METer:DVMeter<m>:ENABle?.........................................................................................700
METer:BANDwidth......................................................................................................... 701
METer:DVMeter<m>:ACRMs:ENABle.............................................................................. 701
METer:DVMeter<m>:ACRMs:RESult?..............................................................................701
METer:DVMeter<m>:DC:ENABle.....................................................................................702
METer:DVMeter<m>:DC:RESult?.................................................................................... 702
METer:DVMeter<m>:DCRMs:ENABle.............................................................................. 702
METer:DVMeter<m>:DCRMs:RESult?..............................................................................702
METer:DVMeter<m>:ENABle?
Queries the state of the voltmeter for the respective channel.
Suffix:
<m>
.
1 to 4, index of the analog channel
Return values:
<State> ON | OFF
*RST: OFF
Usage: Query only
Asynchronous command
Applications