Getting StartedMXO 4 Series
32User Manual 1335.5337.02 ─ 07
●
Ensure that the network settings comply with the security policies of your company.
Contact your local system administrator or IT department before connecting your
product to your company LAN.
●
When connected to the LAN, the product may potentially be accessed from the
internet, which may be a security risk. For example, attackers might misuse or
damage the product.
To connect a LAN cable
► Connect an RJ-45 cable to the LAN connector on the rear panel, and to the LAN.
For supported LAN interfaces, refer to the specifications document.
By default, the MXO 4 is configured to use DHCP. Configuration of a static IP address
is not required.
3.1.8 Connecting external devices
3.1.8.1 Connecting USB devices
You can use USB connectors on the front panel and on the side or rear panel to con-
nect various devices:
●
Connect a keyboard and a mouse for operation and data entry, alternatively or in
addition to the touchscreen functionality.
●
Connect USB flash drives to save screenshots, and to transfer files to and from the
instrument without a network connection.
► Connect the USB device to any of the USB connectors.
You can connect or disconnect USB devices during operation of the instrument.
3.1.8.2 Connecting external monitors
Using the HDMI connector on the rear panel, you can connect an external monitor or
projector to the oscilloscope.
1.
NOTICE! Missing ground contact can damage the oscilloscope.
Ensure that the monitor and the oscilloscope are connected to a ground contact.
See also: Chapter 3.1.6, "Connecting to power", on page 31.
2.
NOTICE! Use only standard-compliant monitor cables.
Connect the monitor or projector to a display connector.
The oscilloscope recognizes the external monitor. During the running session, you
can disconnect the monitor and connect it again.
Preparing for use
To Next Page
Loading...
