Rohde & Schwarz MXO 4 Series - Tracks

Remote control commandsMXO 4 Series
631User Manual 1335.5337.02 ─ 07
Manual operation: See "Upper level, Middle level,Lower level" on page 225
17.12.7 Tracks
MEASurement<mg>:TRACk[:STATe]................................................................................631
MEASurement<mg>:TRACk:AUTO..................................................................................631
MEASurement<mg>:TRACk:CONTiunous........................................................................ 631
MEASurement<mg>:TRACk:OFFSet............................................................................... 632
MEASurement<mg>:TRACk:SCALe................................................................................ 632
MEASurement<mg>:TRACk:DATA:HEADer?....................................................................632
MEASurement<mg>:TRACk:DATA[:VALues]?...................................................................633
MEASurement<mg>:TRACk[:STATe] <State>
Enables or disables the track for the selected measurement.
Suffix:
<mg>
.
1...16, index of the measurement
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "State" on page 239
MEASurement<mg>:TRACk:AUTO
Sets the vertical scale and the offset of the track, so that the complete height of the
diagram is used.
Suffix:
<mg>
.
1...16, index of the measurement
Usage: Event
Asynchronous command
Manual operation: See "Fit to screen" on page 239
MEASurement<mg>:TRACk:CONTiunous <AutoScale>
Performs an automatic scaling whenever the track does not fit in the diagram during
the measurement period.
Suffix:
<mg>
.
1...16, index of the measurement
Parameters:
<AutoScale> ON | OFF
*RST: ON
Automatic measurements