Network operation and remote controlMXO 4 Series
453User Manual 1335.5337.02 ─ 07
Each instrument is delivered with an assigned host name, but you can change this
name.
The default host name is the device name, a non-case-sensitive string with the follow-
ing syntax: <instrument_model>-<serial_number>.
For example, the default host name of an MXO44 with serial number 123456 is
MXO44-123456.
You can find the current host name, the model and the serial number in the "Device
summary", when you tap the Rohde & Schwarz logo in the upper right corner of the
screen. See also: Chapter 4.12, "Information and notifications", on page 70.
The serial number can also be found on the rear panel of the instrument. It is the third
part of the device ID printed on the barcode sticker:
To change the host name
1. Open the "Menu".
2. Select "Settings" > "System" > "Network".
3. In "Device name", enter the new host name.
4. Confirm the entry.
5. Reboot the instrument.
16.2 Web interface
If the MXO 4 is connected to a computer via LAN, you can operate the instrument from
the computer. No additional tools are required, you need only a web browser.
16.2.1 Settings on the MXO 4
The connection status icon in the upper right corner indicates the status of the LAN
connection. A green icon indicates that the instrument is connected to the LAN; a red
symbol indicates a connection error - mostly the LAN cable is not connected.
The "Network" tab of the "System" dialog box provides network information and set-
tings. See Chapter 5.1.2, "Network settings", on page 75.
Web interface
To Next Page
Loading...
