Protocol analysisMXO 4 Series
414User Manual 1335.5337.02 ─ 07
13.8 10BASE-T1S (option R&S MXO4-K560)
10BASE-T1S technology provides a 10 Mbit/s, multidrop transmission over a single
pair physical layer. It is an IEEE standard, defined in the IEEE standard 802.3cg-2019
specification.
Required options and equipment
For performing 10BASE-T1S decode measurements, you need the following equip-
ment:
●
MXO 4. One of the analog input channels is used for analysis.
●
Option R&S MXO4-K560
13.8.1 10BASE-T1S configuration
13.8.1.1 10BASE-T1S configuration settings
Access: [Apps] key > "Protocol" tab > "10Base -T1S" > "Setup".
Make sure that the tab of the correct serial bus is selected.
Protocol type
Displays the protocol type to be decoded.
Remote command:
SBUS<sb>:TYPE on page 704
Source
Selects the source for the 10BASE-T1S protocol. Only analog channels can be used.
10BASE-T1S (option R&S
MXO4-K560)
To Next Page
Loading...
