Rohde & Schwarz MXO 4 Series - Signal Settings

Instrument setupMXO 4 Series
90User Manual 1335.5337.02 ─ 07
Enable
If enabled, each new data point in the diagram area remains on the screen for the
duration that is defined using Time, or as long as Infinite persistence is enabled.
If disabled, the waveform points are displayed only for the current acquisition.
Remote command:
DISPlay:PERSistence[:STATe] on page 499
Infinite persistence
If infinite persistence is enabled, each new waveform point remains on the screen until
this option is disabled. Use infinite persistence to display rare events in the signal.
Remote command:
DISPlay:PERSistence:INFinite on page 498
Time
Sets a time factor that controls how long the waveforms points fade away from the dis-
play. Thus, the MXO 4 emulates the persistence of analog phosphor screens.
Remote command:
DISPlay:PERSistence:TIME on page 498
Reset
Resets the display, removing persistent all waveform points.
Remote command:
DISPlay:PERSistence:RESet on page 498
5.4.2 Signal settings
Access: "Menu" > "Settings" > "Display" > "Signal".
Display settings