Protocol analysisMXO 4 Series
416User Manual 1335.5337.02 ─ 07
Decoding is performed in several steps, and the end results are presented in the
decode table. The decode layer selects an interim step for which the decoding result is
shown in the honeycomb display.
Show symbols
You can load symbol lists, and activate its usage for decoding. As a result, an addi-
tional "Symbol" column appears in the "Decode results" table, containing the symbolic
label.
13.8.2 10BASE-T1S filter
Access: [Apps] key > "Protocol" tab > "10Base -T1S" > "Filter" tab
In the "Filter" tab, you can define the settings to display only the frames that match the
selected filter conditions.
Check all, Clear, Invert, Reset
The following settings help you select the frames and errors you want to filter for. Only
the frames and error types that match the selected filter conditions are displayed.
"Check all"
Enables the filter for all available frames and error types.
"Clear"
Disables the filter for all available frames and error types.
10BASE-T1S (option R&S MXO4-K560)
To Next Page
Loading...
