Rohde & Schwarz MXO 4 Series - SPMI Decode Results

Protocol analysisMXO 4 Series
411User Manual 1335.5337.02 ─ 07
"Data"
The data setup consists of a comparison condition and one or two
data patterns.
Remote command:
SBUS<sb>:SPMI:FILTer:DMAX on page 819
SBUS<sb>:SPMI:FILTer:FRAMe<fr>:FLD<fl>:DMAX
on page 819
SBUS<sb>:SPMI:FILTer:DMIN on page 819
SBUS<sb>:SPMI:FILTer:FRAMe<fr>:FLD<fl>:DMIN
on page 819
SBUS<sb>:SPMI:FILTer:DOPerator on page 819
SBUS<sb>:SPMI:FILTer:FRAMe<fr>:FLD<fl>:DOPerator
on page 819
"Index"
The index setup consists of a comparison condition and one or two
index values.
Remote command:
SBUS<sb>:SPMI:FILTer:IMAX on page 821
SBUS<sb>:SPMI:FILTer:FRAMe<fr>:FLD<fl>:IMAX
on page 821
SBUS<sb>:SPMI:FILTer:IMIN on page 820
SBUS<sb>:SPMI:FILTer:FRAMe<fr>:FLD<fl>:IMIN
on page 820
SBUS<sb>:SPMI:FILTer:IOPerator on page 820
SBUS<sb>:SPMI:FILTer:FRAMe<fr>:FLD<fl>:IOPerator
on page 820
Error type
Enables filtering on the selected error type.
Remote command:
SBUS<sb>:SPMI:FILTer:ERRor<n>:ENABle on page 820
SBUS<sb>:SPMI:FILTer:ERENable on page 820
13.7.3 SPMI decode results
When the configuration of the serial bus is complete, the signal can be decoded:
1. Open the "Serial Bus" dialog for the respective bus.
2. In the "Setup" tab, enable "State".
3. In the "Display" tab, enable "Show decode table".
For a description of the display settings, see also Chapter 13.1.4, "Display",
on page 315.
The instrument captures and decodes the signal according to the standard definition
and the configuration settings.
SPMI (option R&S
MXO4-K550)