Rohde & Schwarz MXO 4 Series - Spectrum Peak List

Spectrum analysisMXO 4 Series
252User Manual 1335.5337.02 ─ 07
Remote command:
CALCulate:SPECtrum<sp>:GATE:STOP on page 654
Position
Sets the position of the displayed frequency range.
The width of the gate is defined using the "Width" setting.
Remote command:
CALCulate:SPECtrum<sp>:GATE:POSition on page 653
Width
Defines the width of the displayed gate.
The position of the span is defined using the "Position" setting.
Remote command:
CALCulate:SPECtrum<sp>:GATE:WIDTh on page 654
10.6 Spectrum peak list
A peak list measurement detects all peaks above a user-definable threshold and
optionally indicates the peaks in the spectrum diagram.
Access: "Menu" > "Spectrum" > "PeakList".
In the peak list dialog, you can define various criteria for a peak search. The peaks can
be indicated in the frequency diagram by peak boxes, and the measured peak frequen-
cies and magnitudes are listed in the peak list table.
Spectrum peak list