Rohde & Schwarz MXO 4 Series - Trigger Types; Edge Trigger

TriggerMXO 4 Series
146User Manual 1335.5337.02 ─ 07
Remote command:
TRIGger:MEVents:SEQuence<se>:COUNt on page 543
Enable reset event
If enabled, the trigger sequence is restarted by the R-trigger condition if the specified
number of B-triggers does not occur before the R-trigger conditions are fulfilled.
Remote command:
TRIGger:MEVents:SEQuence<se>:RESet:EVENt on page 543
Enable reset by time, Reset timeout
If reset timeout is enabled, the instrument waits for the "Reset timeout" time for the
specified number of B-triggers. If no trigger occurs during that time, the sequence is
restarted with the A-trigger.
Remote command:
TRIGger:MEVents:SEQuence<se>:RESet:TIMeout[:ENABle] on page 544
TRIGger:MEVents:SEQuence<se>:RESet:TIMeout:TIME on page 544
7.4 Trigger types
● Edge trigger...........................................................................................................146
● Edge trigger on external trigger source.................................................................147
● Glitch trigger..........................................................................................................149
● Width trigger..........................................................................................................151
● Runt trigger........................................................................................................... 152
● Window trigger...................................................................................................... 154
● Timeout trigger...................................................................................................... 156
● Interval trigger....................................................................................................... 157
● Slew rate trigger....................................................................................................159
● Setup & Hold.........................................................................................................161
● State trigger...........................................................................................................163
● Pattern trigger....................................................................................................... 164
● Line trigger............................................................................................................ 169
7.4.1 Edge trigger
Access: "Menu" > "Trigger" > "Setup" tab > "Type = Edge"
The edge trigger is the most common trigger type. The trigger occurs when the signal
from the trigger source passes the trigger level in the specified direction (slope).
This section describes the trigger-type specific settings. For settings that apply to all
trigger types, see Chapter 7.2, "Common trigger settings", on page 142.
Trigger types