ApplicationsMXO 4 Series
285User Manual 1335.5337.02 ─ 07
11.2.3 Reference level
Some power analysis measurements require reference levels to obtain the measure-
ment points. Power analysis uses its own reference level set, which is independent
from other measurements and is used for all power measurements.
Figure 11-4: Relative reference level
Figure 11-5: Absolute reference level
Level mode
Defines if the reference level is set in absolute or relative values.
Remote command:
POWer<m>:HARMonics:REFLevel<rl>:LMODe on page 695
POWer<m>:QUALity:REFLevel<rl>:LMODe on page 695
Absolute Level mode
In the absolute mode, the reference values are set as voltages, in absolute values.
Upper level, Middle level, Lower level ← Absolute Level mode
Sets the low, middle and upper reference signal levels.
Power analysis (option R&S
MXO4-K31)
To Next Page
Loading...
