Rohde & Schwarz MXO 4 Series - FRA Saving Results

ApplicationsMXO 4 Series
269User Manual 1335.5337.02 ─ 07
●
"Generator"
●
"User load"
●
"Amplitude mode"
●
"Amplitude profile"
●
"Amplitude profile" > "Voltage change"
●
"Start" frequency
●
"Stop" frequency
●
"Points" mode and total points
●
"Measurement delay"
●
"Delay time"
●
"RBW"
The following settings are available for the calibration:
Use calibration data
If enabled, the user calibration data is used for the frequency response analysis.
Remote command:
FRANalysis:CALibration:STATe on page 668
Restore calibration settings
Restores the FRA settings, to the values that were selected during the calibration proc-
ess. This allows you to further perform measurements with a valid calibration state.
See also "Settings influencing calibration" on page 268.
Save/Recall
Opens the "Save/Recall" dialog. You can recall a saved saveset.
Start calibration
Starts the calibration. The button is only enabled, if there is a valid test setup.
The state of the calibration process is displayed in the calibration label in the toolbar.
After a calibration is performed successfully, the calibration values are saved automati-
cally.
Remote command:
FRANalysis:CALibration:CALibration on page 668
FRANalysis:CALibration:RESult? on page 668
11.1.4 FRA saving results
Access: [Apps] > "General" > "FRA" > "Setup" > "Save/Recall" >"Results".
Frequency response analysis (option R&S
MXO4-K36)