Getting StartedMXO 4 Series
30User Manual 1335.5337.02 ─ 07
3.1.4.2 Mounting the product on a monitor arm
You can mount the oscilloscope to a monitor arm with VESA mount.
►
NOTICE! Only use a VESA mount compatible with standard 100 mm × 100 mm
pattern.
Mount the VESA mount of the monitor arm to the VESA mounting holes on the rear
panel of the oscilloscope.
3.1.4.3 Mounting the product in a rack
To prepare the rack
1. Observe the requirements and instructions in "Setting up the product" on page 18.
2.
NOTICE! Insufficient airflow can cause overheating and damage the product.
Design and implement an efficient ventilation concept for the rack.
To mount the oscilloscope in a rack
1. Use a rackmount kit to prepare the instrument for rack mounting.
a) Order the rackmount kit designed for your oscilloscope. For the order number,
see specifications document.
b) Mount the rackmount kit. Follow the assembly instructions provided with the
rackmount kit.
2. Lift the product to shelf height. If the rack is high, use a safe climbing aid when
placing on upper shelves.
3. Grip the product by the handles. Slide the product onto the shelf until the rack
brackets fit closely to the rack.
4. Tighten all screws at the rack brackets with a tightening torque of 1.2 Nm to secure
the product at the rack.
To unmount the product from a rack
1. Loosen the screws at the rack brackets.
2. Remove the product from the rack.
3. If placing the product on a bench top again, unmount the rackmount kit from the
product. Follow the instructions provided with the rackmount kit.
3.1.5 Considerations for test setup
Observe safety instructions, see "Performing measurements" on page 20.
Preparing for use
To Next Page
Loading...
