Rohde & Schwarz MXO 4 Series - Status Reporting; General Commands

Remote control commandsMXO 4 Series
876User Manual 1335.5337.02 ─ 07
Usage: Asynchronous command
Manual operation: See "Amplitude parameters" on page 447
GENerator:SYNC[:COMBination] <Combination>
Selects which signals generated from the waveform generator are synchronized.
Parameters:
<Combination> NONE | GEN12
*RST: NONE
Usage: Asynchronous command
Manual operation: See "Synchron start" on page 446
17.19
Status reporting
This chapter describes the remote commands that are used to read the status regis-
ters.
For information on structure, hierarchy, and contents of the status registers, see Chap-
ter 16.5, "Remote control - status reporting system", on page 462.
● General commands...............................................................................................876
● STATus:OPERation register..................................................................................877
● STATus:QUEStionable registers........................................................................... 878
● Reading out the CONDition part........................................................................... 879
● Reading out the EVENt part..................................................................................880
● Controlling the ENABle part.................................................................................. 881
● Controlling the negative transition part..................................................................881
● Controlling the positive transition part...................................................................882
● Programming tips and examples...........................................................................884
17.19.1 General commands
STATus:PRESet
Resets the status registers.
All PTRansition bits are set to 1, i.e. all transitions from 0 to 1 are detected.
All NTRansition bits are set to 0, i.e. a transition from 1 to 0 in a CONDition bit is
not detected.
All EVENt bits are set to 0.
The ENABle bits of STATus:OPERation and STATus:QUEStionable are set to 0,
i.e. all events in these registers are not passed on.
Status reporting