Rohde & Schwarz MXO 4 Series - UART Decode Results

Protocol analysisMXO 4 Series
363User Manual 1335.5337.02 ─ 07
Data conditions
Specify the data conditions if the trigger type is set to "Data".
Data ← Data conditions
Selects the operator for the "Data" pattern.
Remote command:
TRIGger:UART:FCONdition on page 753
Value ← Data conditions
Specifies the data pattern to be found on the specified trigger source. Enter the words
in MSB first bit order.
Remote command:
TRIGger:UART:DATA on page 753
Position ← Data conditions
Sets the number of words before the first word of interest. These offset words are
ignored.
The setting is available if packet detection is enabled in the protocol configuration.
Remote command:
TRIGger:UART:DPOSition on page 753
13.4.5 UART decode results
When the configuration of the serial bus is complete, the signal can be decoded:
1. Open the "Serial Bus" dialog for the respective bus.
2. In the "Setup" tab, enable "State".
3. In the "Display" tab, enable "Show decode table".
For a description of the display settings, see also Chapter 13.1.4, "Display",
on page 315.
The instrument captures and decodes the signal according to the standard definition
and the configuration settings.
The color-coding of the various protocol sections and errors simplifies the interpretation
of the visual display. The decode information condenses or expands, depending on the
horizontal scale. Various data formats are available to show the result values.
UART (option R&S MXO4-K510)