Rohde & Schwarz MXO 4 Series - LIN Decode Results

Protocol analysisMXO 4 Series
401User Manual 1335.5337.02 ─ 07
"Data"
The data setup consists of a comparison condition and one or two
data patterns.
Remote command:
SBUS<sb>:LIN:FILTer:DMAX on page 803
SBUS<sb>:LIN:FILTer:FRAMe<fr>:FLD<fl>:DMAX
on page 803
SBUS<sb>:LIN:FILTer:DMIN on page 803
SBUS<sb>:LIN:FILTer:FRAMe<fr>:FLD<fl>:DMIN
on page 803
SBUS<sb>:LIN:FILTer:DOPerator on page 804
SBUS<sb>:LIN:FILTer:FRAMe<fr>:FLD<fl>:DOPerator
on page 804
"Index"
The index setup consists of a comparison condition and one or two
index values.
Remote command:
SBUS<sb>:LIN:FILTer:IMAX on page 805
SBUS<sb>:LIN:FILTer:FRAMe<fr>:FLD<fl>:IMAX
on page 805
SBUS<sb>:LIN:FILTer:IMIN on page 805
SBUS<sb>:LIN:FILTer:FRAMe<fr>:FLD<fl>:IMIN
on page 805
SBUS<sb>:LIN:FILTer:IOPerator on page 806
SBUS<sb>:LIN:FILTer:FRAMe<fr>:FLD<fl>:IOPerator
on page 806
Error type
Enables filtering on the selected error type.
The available errors are "Checksum error", "Parity error","Start error", "Sync error",
"Length error" and "Incomplete".
Remote command:
SBUS<sb>:LIN:FILTer:ERENable on page 804
SBUS<sb>:LIN:FILTer:ERRor<n>:ENABle on page 804
13.6.4 LIN decode results
When the configuration of the serial bus is complete, the signal can be decoded:
1. Open the "Serial Bus" dialog for the respective bus.
2. In the "Setup" tab, enable "State".
3. In the "Display" tab, enable "Show decode table".
For a description of the display settings, see also Chapter 13.1.4, "Display",
on page 315.
The instrument captures and decodes the signal according to the standard definition
and the configuration settings.
LIN (option R&S
MXO4-K520)