Rohde & Schwarz MXO 4 Series - Cursor Results

Remote control commandsMXO 4 Series
641User Manual 1335.5337.02 ─ 07
*RST: OFF
Usage: Asynchronous command
Manual operation: See "X, Y" on page 214
CURSor<cu>:X1ENvelope <EnvelopeSelect>
CURSor<cu>:X2ENvelope <EnvelopeSelect>
Define which horizontal cursor is positioned to the maximum and which to the minimum
envelope values.
Prerequisites:
●
ACQuire:TYPE on page 520 is set to ENVElope.
●
CURSor<cu>:TRACking[:STATe] is set to ON.
●
CURSor<cu>:FUNCtion is set to PAIRed.
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<EnvelopeSelect> MIN | MAX
MIN
The horizontal cursor is set to the crossing point of the vertical
cursor with the minimum waveform envelope.
MAX
The horizontal cursor is set to the crossing point of the vertical
cursor with the maximum waveform envelope.
*RST: MAX
Usage: Asynchronous command
Manual operation: See "Envelope, Envelope 2" on page 212
17.13.2 Cursor results
CURSor<cu>:XDELta[:VALue]?.......................................................................................641
CURSor<cu>:XDELta:INVerse?.......................................................................................642
CURSor<cu>:YDELta[:VALue]?.......................................................................................642
CURSor<cu>:YDELta:SLOPe..........................................................................................642
CURSor<cu>:XDELta[:VALue]?
Queries the delta value (distance) of two vertical cursor lines.
Suffix:
<cu>
.
1...2, index of the cursor set
Cursor measurements