Rohde & Schwarz MXO 4 Series - Peak List

Remote control commandsMXO 4 Series
655User Manual 1335.5337.02 ─ 07
17.14.3 Peak list
CALCulate:SPECtrum<sp>:PLISt:COUNt?....................................................................... 655
CALCulate:SPECtrum<sp>:PLISt[:STATe]........................................................................ 655
CALCulate:SPECtrum<sp>:PLISt:MAXCount....................................................................655
CALCulate:SPECtrum<sp>:PLISt:MODE..........................................................................656
CALCulate:SPECtrum<sp>:PLISt:SOURce.......................................................................656
CALCulate:SPECtrum<sp>:PLISt:SPOW..........................................................................656
CALCulate:SPECtrum<sp>:PLISt:RESult[:VALue]?........................................................... 657
CALCulate:SPECtrum<sp>:PLISt:SORT:COLumn............................................................. 657
CALCulate:SPECtrum<sp>:PLISt:SORT:ORDer................................................................657
CALCulate:SPECtrum<sp>:PLISt:LABel:FREQuency[:STATe]............................................ 657
CALCulate:SPECtrum<sp>:PLISt:LABel:MAXCount.......................................................... 658
CALCulate:SPECtrum<sp>:PLISt:LABel:INVert................................................................. 658
CALCulate:SPECtrum<sp>:PLISt:LABel:MAXCount.......................................................... 658
CALCulate:SPECtrum<sp>:PLISt:LABel[:STATe]...............................................................658
CALCulate:SPECtrum<sp>:PLISt:COUNt?
Returns the current number of peak list results.
Suffix:
<sp>
.
1
Return values:
<Count>
Usage: Query only
Asynchronous command
CALCulate:SPECtrum<sp>:PLISt[:STATe] <ShowTable>
Enables the display of the peak table.
Suffix:
<sp>
.
1
Parameters:
<ShowTable> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Peak table" on page 253
CALCulate:SPECtrum<sp>:PLISt:MAXCount <MaxNoRess>
Sets the maximum number of measurement results that are listed in the result table.
Suffix:
<sp>
.
1
Spectrum analysis