Rohde & Schwarz MXO 4 Series - Page 658

Remote control commandsMXO 4 Series
658User Manual 1335.5337.02 ─ 07
Usage: Asynchronous command
Manual operation: See "Show frequency" on page 255
CALCulate:SPECtrum<sp>:PLISt:LABel:MAXCount <MaxNumberPeaks>
Sets the maximum number of measurement results that are listed in the result table.
Suffix:
<sp>
.
1
Parameters:
<MaxNumberPeaks> Range: 1 to 100
Increment: 1
*RST: 10
Usage: Asynchronous command
CALCulate:SPECtrum<sp>:PLISt:LABel:INVert
<Inverse>
Inverts the colors of the peak list labels, the peak boxes are shown with a white back-
ground.
Suffix:
<sp>
.
1
Parameters:
<Inverse> ON | OFF
*RST: OFF
Usage: Asynchronous command
CALCulate:SPECtrum<sp>:PLISt:LABel:MAXCount <MaxNumberPeaks>
Sets the maximum number of measurement results that are listed in the result table.
Suffix:
<sp>
.
1
Parameters:
<MaxNumberPeaks> Range: 1 to 100
Increment: 1
*RST: 10
Usage: Asynchronous command
CALCulate:SPECtrum<sp>:PLISt:LABel[:STATe] <ShowLabels>
Displays the labels in the peak list diagram.
Suffix:
<sp>
.
1
Spectrum analysis