Remote control commandsMXO 4 Series
606User Manual 1335.5337.02 ─ 07
17.11.2 Saveset
SAVeset:CONFig:PREView <IncludeImage>
If set to OFF, the saveset is stored without the preview image to reduce the file size.
Use the command each time before you save a saveset.
Parameters:
<IncludeImage> ON | OFF
*RST: ON
Usage: Asynchronous command
17.11.3
Gen saveset
GENerator:RCL <filePath>
Restores the waveform generator from the specified file.
Parameters:
<filePath> String parameter specifying the path and filename of the source
file.
Usage: Asynchronous command
GENerator:SAV <filePath>
Stores the current waveform generator settings to the specified file.
Parameters:
<filePath> String parameter specifying path and filename of the target file.
Usage: Asynchronous command
17.11.4 Waveform export to file
EXPort:WAVeform:NAME................................................................................................606
EXPort:WAVeform:SAVE.................................................................................................607
EXPort:WAVeform:ABORt............................................................................................... 607
EXPort:WAVeform:SCOPe.............................................................................................. 607
EXPort:WAVeform:SOURce............................................................................................ 608
EXPort:WAVeform:STARt................................................................................................608
EXPort:WAVeform:STOP................................................................................................ 608
EXPort:WAVeform:GATE................................................................................................ 609
EXPort:WAVeform:CURSorset.........................................................................................609
EXPort:WAVeform:NAME <name>
Sets the path, the filename and the file format of the export file.
Data management
To Next Page
Loading...
