Rohde & Schwarz MXO 4 Series - Page 608

Remote control commandsMXO 4 Series
608User Manual 1335.5337.02 ─ 07
MANual
Saves the data between user-defined start and stop values to be
set with EXPort:WAVeform:STARt and EXPort:WAVeform:
STOP.
*RST: DISPlay
Example: See Chapter 17.4.3, "Data transfer in roll mode", on page 479.
Usage: Asynchronous command
Manual operation: See "Export mode" on page 298
EXPort:WAVeform:SOURce <Source>
Selects the waveform to be exported to file.
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9
| D10 | D11 | D12 | D13 | D14 | D15 | M1 | M2 | M3 | M4 | M5 |
R1 | R2 | R3 | R4 | SPECMAXH1 | SPECMINH1 | SPECNORM1
| SPECAVER1 | HARMonics1 | HARMonics2 | HARMonics3 |
Usage: Asynchronous command
Manual operation: See "Source" on page 298
EXPort:WAVeform:STARt <Start>
Sets the start time value of the waveform section for export, if EXPort:WAVeform:
SCOPe on page 607 is set to Manual.
Parameters:
<Start> Range: -1E+26 to 1E+26
Increment: 0.01
*RST: 0.01
Default unit: s
Usage: Asynchronous command
Manual operation: See "Export mode" on page 298
EXPort:WAVeform:STOP <Stop>
Sets the end time value of the waveform section for export, if EXPort:WAVeform:
SCOPe on page 607 is set to Manual.
Parameters:
<Stop> Range: -1E+26 to 1E+26
Increment: 0.01
*RST: 0.01
Default unit: s
Usage: Asynchronous command
Data management