Data and file managementMXO 4 Series
298User Manual 1335.5337.02 ─ 07
Source
Selects the waveform to be exported. The list shows all active waveform that can be
exported.
Remote command:
EXPort:WAVeform:SOURce on page 608
Export mode
Defines the part of the waveform record that has to be stored.
"Display"
Saves the waveform data that is displayed in the diagram.
"All data"
Saves the complete waveform record.
"Cursor"
Saves the data between the cursor lines if at least one cursor mea-
surement is defined for the source waveform. If several cursor sets
are defined, select the "Cursor set" to be used for export.
Save and recall waveform data
To Next Page
Loading...
