Protocol analysisMXO 4 Series
314User Manual 1335.5337.02 ─ 07
Remote command:
SBUS<sb>:TYPE on page 704
State
Enables the decoding of the selected bus. The signal icon of the bus appears on the
signal bar.
13.1.2 Thresholds
In the "Thresholds" tab, you can set values for threshold and hysteresis.
Show threshold lines
Enables the display of the threshold lines in the diagram.
The label of the threshold line is set according to the signal that it is referring to. It is
displayed in the color of the signal channel.
Basics of protocol analysis
To Next Page
Loading...
